Jump to content

    finaly found some 16" rims for my Caravan

    Shelby
    By Shelby,
    had some all this time I forgot I had 2 1/2 sets of Eagle talon rims this was a set of TSI rims that I had to open the hub bore up to fit a chyr full size but with 225x60x16" I think they look OK , and enough side wall to make the ride about the same 26.63 inches tallhttp://www.26liter.us/gallery/albums/userpics/10009/100_0876.JPG I still need to clean up and reclear them but for now i'm on the road again after busting two tires cords on a rut on the road side a couple weeks ago

    TPS Sensor

    iGSR_VR
    By iGSR_VR,
    In need of a good working TPS sensore for an 86   Don't know if there all the same???

    The Nerve of dgcanales90

    importdriver88
    By importdriver88,
    As you may or may not know, i have sold more than a few rebuilt 16g, s16g and 14b turbos to members on this forum. The last 14b turbo transaction is the one of topic. Member pm's me with interest on 14b turbo, then a little time goes by. So i contact him to see what up. I get story about his kid ending up in hospital, i said "cool- i will hold the turbo for you". More time goes by, so i contact him again. He now had to wait for the end of the week. The 14b turbo gets sold on 25 October 2013. Min

    lots of parts and a roller

    eck_007
    By eck_007,
    Ok, I have an 88 roller automatic car. It has everything except the engine. I also have a TON of extra parts I have collected over the past 10 years. Everything from doors to engine parts, a 4g63 wideblock bottom end, a complete interior, full front and rear suspension, complete rearend assembly and a ton of electrical parts and stuff. I dont want to scrap it but I need it gone and i could realy use some cash right now. $1500 obo Here is a pic of the roller.I have more pics upon request.  

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...