OK, since nobody seems to have an ECU diagram for an 86 Starion, I went and purchased a manual. (I was going to anyhow, but the need for it got me off my butt)   I used terminals A11 and A4 for the A/F meter.   It works perfectly. Only one light at a time lights up.   Not 2, not 4, just 1.     The only thing about looking at the diagram show is that you need to remember its a top down view of the ECU connector, NOT the plug you pulled out of it.   So when it refers to "Connector A",

Hey fellow 'questers!   I have just imported a set of '89 quest taillights into Australia and wish to do the de-lensing thing.... any hints? Do you warm 'em up in the oven, not too hot so it melts the cover, just warm enough to soften the polyeurathane sealant? What temperature would the be, roughly? (degrees celsius pleeeeze, otherwise I have to do that divide by 1.2, minus 32 thing or whatever, and my brain is just not ready for that!) I only have one chance to bugger these lights up, so a

Hey guys, I bought a 84 Supra hatch shade off of a guy from the boards about 2 yrs ago but never put it on my Quest 'cause I could never figure out how to do it. I see that some of you have done this mod. How did you do it?  I gotta get that thing on there so any help would be appreciated.   Thanks, Jerry

ok, i just recently did my intercooler setup on my car and i must say it turned out better than expected. basically, i used the existing holes behind the headlight motors to get my pipes in/out of the engine bay...  an i even kept the charcoal canister! front http://us.f1.yahoofs.com/users/a71d304f/bc...c04Pg9ANNRDB9IM pass side http://us.f1.yahoofs.com/users/a71d304f/bc...c04Pg9AzUec1BMt drivers side http://us.f1.yahoofs.com/users/a71d304f/bc...c04Pg9AdTSjJ3WX   and i only had to make