Well i have finally decide that i'm going with MAGNA MPI, i don't know if i can modified the Magna with a 72mm T-body from Ford, with Megasquirt computer system, iguess its lot better i will wait when it comes out the Megasquirt II(2), i'm going to get 3 angle valve job port and polish, with arp head studs, 3 stage ACT clutch, 20-22lbs. flywheel modified from TEP,race cam, Wiseco Pistons, 3 inch EIP down pipe, 3 inch Exhaust, GT-Series Turbo (it makes around 260 to 350HP the turbo it self GT- SE

A 12" subwoofer I'm interested in has a recommended cubic feet volume of 0.8-1.5. Now, my question is, is this number recommended MINIMUM or is it the IDEAL?   By minimum, I mean, as long as the cubic volume doesn't get any smaller than that, it's ok OR, by ideal, I mean, the cubic volume must be within that cubic feet range, no more no less?   Will going beyond that 0.8-1.5 range make the woofer inefficient?   Thanks, MANGO

Guys I've had a couple of daily drivers that are hondas. I've also been looking at the PGMFI.org website and have come to the conclusion that the cheapest engine management system for our cars would be to convert the honda SOHC system to suit the conquest. The software to data log and alter the ecu is all free. The only parts you need cheap. Here's the short list...   ECU -pm6 from the MPI 1.5L sohc civic or crx Distributor from the same car*has a cam angle sensor built in Map Sensor Throttle po

I have an 88 tsi shp conquest and was wondering if sentra spec v seats would fit into the car (i know the seats rails would have to be modified)   does anyone know ?