I have an oil leak around the knock sensor. Does it pass through an oil passage, or should I look elsewhere?

Ok I'll make this short and quick. I run a 17c at 20psi. Dads njv head S's valves. Went to this setup about 5k 6k miles ago. I went on a fun run late last night. Running it hard. Had it up to 140 mph. Got home notice a miss. Check the car today after work. Had oil in all ic pipes and intercooler. Cleaned it all out. And restarted it.Car smokes out of oil separator wen running and oil dipstick if pulled out. Guessing alot of blowby. Pulled all plugs they looked good no oil. Did a hot compression

88-89 Wire harness needed. Not sure if an 87 will have the wire color codes.   I need to repair some of the brittle wires that have snapped in the engine bay by the throttle body. I plan to use some of the wire under the fender to replace the brittle stuff by the throttle body.

Hey guys. Just got my car Dyno tuned today and I was pretty nervous just because I don't really beat on my car since it wasn't tuned right. But the best pull it did today was 344hp and 294tq. At 25psi   Mod list: Turbo lab billet 11blade td06sl2 shaft 20g Tbi delphi 650/950 2.5in ic pips Greddy big front mount Gm 3in maf and maft (zeroed out) Safc2 to tune Msd6al2 and blaster coil HyperU 8.5comp pistons Fresh head 17lb flywheel Walboro 255 Tomei afpr Plugs gapped at .32 Hallman pro mbc   I'm