- 1 reply
- 477 views
- Add Reply
- 11 replies
- 1543 views
- Add Reply
- 10 replies
- 1524 views
- Add Reply
- 18 replies
- 1311 views
- Add Reply
TAN RADIO SIDE PANELS
By starquestJOE,
I have and clean set of tan radio side panels. Carpet is clean and not peeling. $65 shipped/pp fee Also have more 88 tan interior parts. Please pm me with questions about them. Have black topped rear tan seats as well. Will get pics up soon
Manual trans fluid debates
By questtuner82,
Okay so I'm at a debate with some people about what kind of fluid to use in the manual trans in these cars...... Factory oil was called diaqueen and ppl say it's the same as gl-4 80/90 gear oil which after contacting mitsubishi I found out that it is nothing like it. The diaqueen is actually a hypoid oil..... Thinner and is compatible with synchros and yellow metals. Everybody says to use sta-lube gear oil but if you read on it it shows it's for (nonsynchronized) transmissions. The km-132 trans
Gibby's new beater with a heater!
By carguygibby,
I was just given a 1996 Volvo 850 2.4l (bummer it's not a turbo) station wagon a few weeks ago. It was about to go off to the crusher as it was overheating and had dropped a ball joint which also wrecked the driver's side CV axle. I had the car towed to my house where I put on a new water pump along with hoses and a thermostat. I found out the timing belt had been replaced recently but whoever did the job didn't do the pump. Really?http://volvoforums.com/forum/images/smilies/confused.gif I then
drilling concrete
By ucw458,
Drilling concrete without a proper hammer drill SUCKS. All I have is a cordless hammer drill with lipo batteries that don't last long. To top it off this concrete has been here since the early 70s and it's SUPER hard. The demo guys that replaced my front walkway spent 3 hours trying to remove a 6'x3' section. I need to drill x4 1/2" holes for inserts so I can bolt my hydrolic press down. I killed 3 batteries and haven't finished 1 hole. This is gonna take forever. /end rant
