$30 shipped. This is the gauge, it does not have the mounting bracket for the back. Replaced with a XD-1 Wideband, no longer needed. No instructions included, but easy to install.   Prefer Money Order, no paypal. If I know you, a check will be fine also.   Red wire = positive Black wire = ground Purple wire = to unshielded part of O2 wire at the ECU.   Jimmy   http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTIyMjIxMjZzNDEzZGZkMzF5NTQx.jpg

$30 shipped. Tested on my car and works fine. There is no connector with this MAS.   Prefer Money Order, will take personal check if I know you.   Jimmy   http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTE1MjQ2ODZzNDEzZGZkMzF5NTQx.jpg   http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTE1MjQ2NTZzNDEzZGZkMzF5NTQx.jpg

IndyFAQ: Car Audio Forums   http://www.caraudioforum.com/vbb3/forumdisplay.php?f=3     Good Car Audio On-line Retailers http://www.onlinecarstereo.com http://www.woofersetc.com http://www.partsexpress.com (for dayton equipment) http://ww.etronics.com   Bad Car Audio On-line Retailers http://www.ikesound.com -- known to sell used equip, boxed as new http://www.sonicelectronix.com -- sold without warranty

I'm working on a swap that I will need some chassis advice on. My swap consists of putting a turbo'd SHO (Yamaha V-6) engine into my 1988 Conquest TSi. The stock engine support/cross-member will have to be removed to make this happen. What I need advice on is how to go about moving the cross-member foward and at the same time, make it stronger. Another thing, is it possible to cut and move the main steering arm? Here are a few pics.   Stock design http://www.mustangmods.com/ims/u/447/527/41265.