juneauto1

new wide-body quarter driver side rear, for sale still in box from dealer asking $300.

Hey can you post more details and pix of your swap, I like a quality setup that i can learn from. I have 6 bolt 4G63 no car yet.

Any idea when this setup will be for sale again.

any update to where those struts can be purchased. I would like to buy a set to make a coilover setup for my starquest. did anyone contast these guys.

Its been some time since the last BP, is it that hard to get parts to build this setup if the strut is from china. this seems to be a copy of the coilover system a nissan club in AZ is using.

For a good race bottom. H beam rods, forged pistons, total seal rings, balance shaft eliminator kit, new oil pump. metal head gasket, O ring block, ARP studs and most important BALANCE everything. I purchased my valves, rods and pistons from www.manleyperformance.com you will have to send your old parts for them to get the spec if you dont know it. local drag race shops in VA with a line boar, crank balancing and other equipment are a good sign they may have what it takes to put your engine togeather. you may have to upgrade that turbo depending on your setup and tuning. I think it will run out of pressure on the topend you may have to use a bigger unit. dont use turbonetics junky units they cant take high oil pressure and will blow the oil seal smoke after a couple days driving, try a Garrett GT turbo its worth it.

I contacted MK1 he no new units for sale and did not know when he would. did his last GP coilover setup sell out!! any how I want to fab my own just point me in the right direction to buy the parts.

WHO MAKES THAT SHOCK FOR THE COILOVER SETUP, WHERE CAN I BUY THE PARTS. WANT TO FABRICATE A SET AS NO SYSTEM IS CURRENTLY FOR SALE.

guys be easy, I never said the car was ready for a pass at the local drag strip or car show its now 80% done after 3 weeks. the car will be srtipped of for its trip to the body shop. dont hate appreciate

Yes they are 19" WORK VS wheels from the supra. they bairly fit the back has a spacer. I have more pix but cant load them I dropped the file size and type and still load error what am i doing wrong

The car runs fine, it was not difficult to make the change, engine and tranny mounts were fabbed in less than a hour engine and tranny dropped right in with minor clarance issues. the car used a levle10 supra auto trans that fits in the tunnel no shift mods nessary. the orignal car ran 10 sec Q-mile times at englishtown NJ before being crashed twice on the street now being reborn a Starquest.

It is from that 10 sec supra, how ever i have not seen any 2JZ starquest this this good.

I want it asap I sent you a message the price works for me

check out my friends 2JZ Starquest, It was started last weekend. more pix later

count me in

I pm you

most of the parts are on e-bay, you have to know what parts you need to make it work for you. haltech e6k $500 used on ebay, use stock dis to trigger the haltech 4 eagle talon injectors 550cc $100 ebay, 4 injector holders(greddy) $30 ebay fuel presure regulator (paxton) ebay $40 i have seen starquest using the eagle talon ecu and harness, very cheap.

check ATPTURBO.com

wanted 88-89 starquest dead or alive in metro NYC area, [-X NO RUST.

is their am update on this project. :?:

I and 3 other friends in the NYC area have had that manifold for over 5 years. they have cracks at the weld joints. i debured and added a brace to mine before i installed it back then and no cracks yet