slk88

bump

bump

Oh Ok ill try that, just fyi though it pops up but doesn't go back down when I press the off button...

bump

I want to add that I don't have a ground which hooks up to the coil bracket that contains a small square black box resistor and runs from a white wire/connector into the driver side harness. For some reason the harness that I have is missing the resistor ground and the white wires/connector that feed into it. The root of my problem might be here I am thinking since the mixed voltage signal I am reading on my voltmeter is showing Millivolts which climbs from 20mv all the way to 200mV then .5V and keeps circling back down to 20mV again?

Hello all, I have had this problem after swapping out the original harness with another one bought off a forum member. In fact I have had this same problem on my 88 Mitsubishi Starion with two swapped harnesses. The problem to put it in the simplest way is that I'm receiving a mixed positive voltage signal on 1 of the two injector terminals that should be reading 0 volts. The other injector terminal reads a perfect +12.8 volts as it should be. I am also getting the mixed positive signal reading on various other connector wires that should be giving me a ground signal. Most of these wires are on the relay connector wires for Alarm and AC functions behind the battery. Also I am getting a reading of 0 volts on some of those relay wires that should be getting a +12 volt signal. This problem is driving me nuts I have checked all the ground wires in the car for good contact and fuses including the fusible links.

Nvm delete please...

I am looking for a working pop up light switch that goes on the gauge hood on the left side to turn on and off the pop up lights. Please let me know if you have one asap. Thanks -Patrick

Just like the title sayings I want to purchase a good working condition 88 Mitsubishi Starion ETACS unit. Please let me know if you have one...

$300 shipped

Can't believe these haven't sold yet. Someone take these beauties off my hands!

bump

Check your pm box Carlos.

$350 shipped now. Don't need these anymore went back to stock.

bump

bump

Obo

I noticed there are two passing relays one in the engine bay above the master cylinder and one inside the cabin next to the center console. Does anyone know why this is?

Just as the title says I'm looking for a good condition Mitsubishi Starion Driver's side taillight that is complete and fully working. Please pm me if you have it. Thanks!

Sold.,

obo

What is the passing relay for anyways?

bump

Interesting I have a custom regrind 284h cam from TEP and it lopes pretty bad. I do also have a 1.6 rollers and HD springs so maybe has something to do with it!

Nice quest and welcome to the boards. I am in Glendale area of los Angeles. Did you get a custom spec on the TEP cam? -Patrick