macrophage

Do you know any chicks that can sew? they can make you 1 or 2 out of leather 2 tone or one color check with the chicks.

what should the color be if water is present

you askin me?

You could probably check the spark plugs the one with the white stuff is probably water.

I had a similar problem when i first got my squest only difference was when i idled at the light i was cool, but when the light turned green i mash the gas and white smoke would come out i later found out it was the intake and exhaust seals. At low RPMs it will leak oil in the comb chamber when you raise the rpm it burns oil then stops because the oil is moving too fast to got into the chambers, thats why i didnt get a lot of smoke when i drove.

Put the honey back in then see what happens.

Ok here,s the deal. There's 11k members that will eventually need struts we need to petition to one of the companies very soon while they still have the templates that we need the parts to continue. I think with enough intrest they will continue to make them but with limited time. Just time enough for all of us to purchase maybe two sets each. But regardless to what somebody's going to have to make them. it wont be before long that some unknown company will start to make them. in the mean time i dont know.

You Might have a broken wastegate or somethin,You said it was boosting before, go over it again you might be missing somethin

Thank You Dad, Why the offset pin?

Thanx for the info but if i dont find some you can bet i will make my own.

Whats the best piston for a basic 300HP performance motor?

no i have the regular set up but im serious about modifying the existing struts

What do we do now that the struts are gone? My plan is to just make them some how by using the parts off the old strut and welding them to some new strut. I know it sounds crazy but we did everything else to these cars.

EF IT! I WILL MAKE MY OWN- how hard is it to torch off the mounting plates and weld them to another.

OK lets get mookeh to make them

YOU GOT THE OFFSETS CORRECT MY SIZES ARE THE SAME EXCEPT FOR THE FRONT IS 18 EVENLY YOU ARE PROBABLY GOING TO NEED A 1.25 SPACER 5X4.50 OR 114.3 TO 5X4.50 FROM LAKESHORE TIRE AND WHEEL PDX87 is correct on the rear.

Remember that u are dealing with an electronic circuit if something goes you CAN get phenomenon LIKE THIS, UNLESS something is blown.

This thing of putting ATF in the power steering totally buggs me out but that is what the FSM says sometimes i think its a misprint.

i knew you were going to take this personal. lol

No ofense but these plates are obviously for people who cant make parts out of metal. this plate is dumb easy to make yourself. Not to hurt the seller but make parts we really need.

About the cheap DVM. you need to purchase a good, one the cheap models are sometimes off by a few volts, you dont have to buy a "Fluke" but a good one.

Try "Turbocity" on line for replacement kits.

Like i was saying before. make sure that the knock box is grounded properly so the voltage can go to ground like it should. otherwise it will blow out.

Yeah if the dealer dont have the part then goto people like McMaster-Carr or goto" thomas register" online they know thousands of nut companies, They might send you a couple as free samples!

Mine does that also especially after high speeds i think it needs oil in it but i will be upgrading to a 88 rear.