Albatross Posted August 19, 2007 Report Share Posted August 19, 2007 IMPORTANT NOTE: Do NOT burn tables ('Calibrate AFR Table' or 'Calibrate Thermistor Tables') on a running engine. Even idle is NOT allowed, because these tables ONLY exist in flash, so once a table is erased, there is nothing but garbage in there until it is re-programmed, one word at a time. Until that reprogramming is complete, operating the engine is unsafe. Ok, I did that: calibrated thermistors with engine running. MSII, V3, variant 028. So how do I do this reprogramming? BTW, the thermistors show accurate reading now. Is reprogramming still necessary? Link to comment Share on other sites More sharing options...
ESIrType? Posted August 20, 2007 Report Share Posted August 20, 2007 If everything is running smoothly, I don't think you need to do anything. If you're in doubt, backup you MS settings, export your tables and reflash the firmware, then for you thermo tables. Then import all you settings. Shawn Link to comment Share on other sites More sharing options...
Indiana Posted August 20, 2007 Report Share Posted August 20, 2007 you end up burning many many many MANY times while tuning don't worry about it, just do it again Link to comment Share on other sites More sharing options...
Recommended Posts