j5 Posted July 11, 2003 Report Share Posted July 11, 2003 It's ALIVE! My sds 4f magna intake set up fired up on the first crank! Idle is decent but looks like it can get better! Then I took it around the block without even programming it. Drove decent out of the box. Well, I'll be taking it easy for a thousand miles while the engine breaks in. j5 Link to comment Share on other sites More sharing options...
Boosted_One Posted July 11, 2003 Report Share Posted July 11, 2003 Good work! The SDS sure is simple to set up isn't it? On my 1st install it fired up likewise right away. Add another to the MPI list! ;D Link to comment Share on other sites More sharing options...
WTFISIT Posted July 13, 2003 Report Share Posted July 13, 2003 So J5, did you use the solid OEM pulley that Mike (Boosted One) used for the trigger magnets? Â I'll need to figure out that part of my setup soon, so I'm curious. Josh Link to comment Share on other sites More sharing options...
j5 Posted July 14, 2003 Author Report Share Posted July 14, 2003 So J5, did you use the solid OEM pulley that Mike (Boosted One) used for the trigger magnets? Â I'll need to figure out that part of my setup soon, so I'm curious. Josh Sure did, Just make sure the scribe mark from the laith is deep enough. So when you punch mark and drill the pully, the punch mark and drill bit stays put. Phasing the magnets was strieght forward. Measure twice and to make sure the calculations are right. Follow the instructions to the wire and everything should be good. The hardest part was the bracket and its placement. j5 Link to comment Share on other sites More sharing options...
Recommended Posts