Jump to content



MotoCam360 Radio Panels


  • Please log in to reply
158 replies to this topic

#21 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 20 April 2014 - 10:10 PM

Looks like you need to file down the bottom leg so the entire unit has a slip fit.  Once you've relieved the panel enough to slide the head unit all the way through the rectangular cutout you'll have full control access and LCD tilt function right?  A $10 flat edge file from home depot should clean up that bottom leg pretty fast I would think and give you square corners that you'll need for the slip-thru fit.
Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest





#22 nixon1237

nixon1237

    Member

  • Members
  • PipPipPip
  • 23 posts
  • Gender:Male
  • Location:Florida
  • Model:Starion

Posted 06 October 2014 - 03:13 AM

Could you do a single din top for a console with garage door?
1985 technica parting out due to massive rot.
1988 Conquest Rio Red stock (totaled)
1988 Starion Red building now mpi ms cop mm dizzy on fresh rebuild and 18g.

#23 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 06 October 2014 - 12:16 PM

Yeah we can make anything, but I would have to get a garage door in hand to take measurements.  We also have to do a run of 6 pieces minimum on anything we produce.
Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest

#24 sellerfeller

sellerfeller

    Member

  • Members
  • PipPipPip
  • 488 posts
  • Gender:Male
  • Location:Florence, Alabama
  • Model:Starion

Posted 17 November 2014 - 09:36 PM

needing a couple of these... pm'd
Posted Image
87 Starion - rocky white
88 Starion - palermo gray

#25 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 25 November 2014 - 05:26 PM

Single DIN with HVAC controls made out of .25" aluminum:

Posted Image


Posted Image

Edited by MotoCam360, 25 November 2014 - 05:28 PM.

Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest

#26 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 23 January 2015 - 08:53 PM

We have 5 of these aluminum radio panels with hvac controls below in stock now:

Posted Image

Shown here in carbon fiber covering.

Edited by MotoCam360, 23 January 2015 - 08:54 PM.

Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest

#27 randy

randy

    Established Member

  • Members
  • PipPipPip
  • 4,109 posts
  • Interests:Starquests forever!
  • Model:Other

Posted 24 January 2015 - 07:11 AM

How much are the carbon fibre one's that are posted?

#28 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 24 January 2015 - 01:27 PM

$68 delivered for the radio panel.  $25 delivered for the 3gauge panel.

PP: sales@mitsubeasty.com
Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest

#29 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 01 February 2015 - 01:06 AM

Bling Bling

Posted Image
Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest

#30 Xtreme Industries

Xtreme Industries

    Established Member

  • Members
  • PipPipPip
  • 1,538 posts
  • Gender:Male
  • Location:Calgary, Alberta
  • Interests:cars
  • Model:Conquest

Posted 11 February 2015 - 11:26 AM

is there any wiring involved when moving the HVAC panel down
2010 Camaro RS - long tube headers, intake isolator, injen intake, ported throtle body, eibach lowering springs, eibach sway bars, pypes cat back exhaust, rx catch can, transformers decals.
1987 Conquest TSI, 5 spd, B71- 3" *DM Exhaust, Hooker ACM, Hood Struts, Taylor wires, silicone vac lines, fidanza, ACT Extreme, MK1 hard pipes, mbc (13psi), MK1 Shifter, MK1 steering wheel, silicone rad hoses, shp wheels - RIP
1991 BMW 318i - RIP

#31 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 12 February 2015 - 02:06 AM

if you relocate the brain box down low, then no there is no wire modifications needed.  Just reroute the factory harness to the new location.

The only caveat is the existing control box sitting on the tranny tunnel will need to be moved over a bit to make room for the hvac brain box on the tunnel
Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest

#32 bflann

bflann

    Member

  • Members
  • PipPipPip
  • 269 posts
  • Gender:Male
  • Location:Florida
  • Model:Conquest

Posted 30 March 2015 - 05:26 PM

do u have any of the original double din w/ 3 gauge, bezels avail in black

#33 Evoz17

Evoz17

    Member

  • Members
  • PipPipPip
  • 163 posts
  • Gender:Male
  • Location:Washington
  • Interests:Mitsubishi's, soccer, life
  • Model:Starion

Posted 02 April 2015 - 03:12 PM

Motocam Can i get a aluminum panel with double din and HVAC on bottom and a aluminum three 52mm gauge panel for the oem HAVC slot?

#34 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 02 April 2015 - 03:29 PM

This is what I have in stock right now:

Posted Image

Posted Image

Posted Image
Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest

#35 Evoz17

Evoz17

    Member

  • Members
  • PipPipPip
  • 163 posts
  • Gender:Male
  • Location:Washington
  • Interests:Mitsubishi's, soccer, life
  • Model:Starion

Posted 02 April 2015 - 05:36 PM

Let me know when you could get one done per my request if at all possible as those really dont suit me.

#36 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 02 April 2015 - 07:21 PM

we'd have to GP a minimum of 6 for that combo
Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest

#37 Evoz17

Evoz17

    Member

  • Members
  • PipPipPip
  • 163 posts
  • Gender:Male
  • Location:Washington
  • Interests:Mitsubishi's, soccer, life
  • Model:Starion

Posted 03 April 2015 - 04:25 PM

Put me down for one set. Hopefully theres more people.

#38 D-VO

D-VO

    Member

  • Members
  • PipPipPip
  • 436 posts
  • Gender:Male
  • Location:Chicago IL
  • Model:Starion

Posted 09 April 2015 - 01:43 PM

Are you waterjet cutting these? They look nice. If I sent a .dxf or Solidworks file, can you do custom work?

#39 MotoCam360

MotoCam360

    Motocam360

  • Vendors
  • PipPipPip
  • 2,148 posts
  • Gender:Male
  • Location:Seattle
  • Interests:SQ, SY/TY, BMW, electronics, motorcycles, snowbikes
  • Model:Conquest

Posted 10 April 2015 - 01:44 AM

WJ cut..... 6 unit minimum
Tim

My Feedback Link
'87 Red 5spd | '87 Atlantic Blue 5spd | '88 Yellow auto | '88 Fiji Auto | '89 Fiji auto
Posted Image
  New/Used SQ parts can be found on Ebay under "MotoCam360"
website: https://www.motocam3...ducts/starquest

#40 bflann

bflann

    Member

  • Members
  • PipPipPip
  • 269 posts
  • Gender:Male
  • Location:Florida
  • Model:Conquest

Posted 11 April 2015 - 06:23 PM

PayPal  sent , pm'd




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users