i'm not, as usual i have the axles rebooted but still need to install rear calipers, rear brake lines, driveshaft, and short shifter, bleed brake system, grease e brake cables, fill trans and diff, put wheels on with noo tires n lugs and test drive. gotta get busy ... oh, and get beer n booze

Been a while since I've tinkered on a SQ and got the itch to MPI my flatty. Need a set of (4) small injectors preferably in the 550 range and low impedance. Everything I have is 750 or bigger and no intentions of big power on this one so would love to find a set in the 550 range.

Hey all, trying to clean up all the junk from my parents garage that I dont want to move to mine. I have a lot of stuff. I dont mind shipping the small stuff, but bigger stuff would be for pick up only. All prices are plus shipping/ paypal fees.       88-89 240mm flywheels. 1 is the stock weight, the other has been lightened to 21.5 pounds. $60 for the stocker.   http://i45.photobucket.com/albums/f79/philipbmckinney/IMG_20150628_201025194_zps0e7q7jeb.jpg   http://i45.photobucket.com/albums/f79/p

Just thought I'd post this process and the results. Thanks Nathan for getting these decals made!   Take it all apart and clean the electrics as usual. There are some other writeups about this if you haven't done it before. Its a jigsaw puzzle, make sure you are working in an area where you can't loose parts.   Housing: Sand the housing with 1000grit to remove the old wording and to give the paint a good surface. Clean with a good prep chemical. I used two light coats of Duplicolor automotive