I just installed a 6al MSD and I am having some problems.I used this for wiring http://www.starquest...showtopic=58296. The only thing I changed was I wired my heavy positive to the battery until I find a switched source on the drivers side of the car. My problem is the tech is jumping weird and the car is running leaner then before the install. It seams to run ok but something dose not seem right.   Also I am running a Gen 2 maft witch I have a tech wire running out of the 6al port on the side

Ok so i have an 88 starion, factory motor, 1g dsm MAF, BOV, and Blaster 2 coil... When i start my car after she sits for a while (at least a few hours) its starts but idles pooly... as if its missing on a cylinder or two. and a giant puff of white smoke comes out the tail pipe. give it a few good revs or let it idle about a min or two and its smooths out... Im thinking its got leaky valve seals but wanted to ask to see if its something special with the cars or anyone has suggestions.. other than

Ok, I searched the forums for similar issue, and tried some things,still won't start. Since I last started it, I changed the in tank fuel filter, main fuel filter in engine bay, master cylinder replace, PVC valve replaced. After doing this I decided to clean engine bay this morning. I didn't have battery in the car while working on these things, so I pushed the car out of garage, covered pretty much entire right side of bay covering coil, and battery cables/electrical components, I tried to be c

I got an 88 hub that I want to use in my 86. Will the matching 6 bolt axle work with an 86 rear end?