-
Images
- 5 replies
- 537 views
- Add Reply
- 12 replies
- 678 views
- Add Reply
- 35 replies
- 9502 views
- Add Reply
- 6 replies
- 677 views
- Add Reply
4 Bolt Rear Axle
By gottraction,
Looking for a 1987 4 Bolt intercooled Drivers side rear axle thats in good shape! Shipped to 30083!!! Thanks
A Song Which Sums Up This Past Presidential Election
By Starfighterpilot,
Listening to my Windows Media Player songs today I ran across this Simon & Garfunkel "Oldie But Goodie" which typifies this past Presidential Election. I found it on U-Tube. http://www.youtube.com/watch?v=m_jmDscGi7E&feature=related Especially listen to the verses: "Sitting on a sofa on a Sunday afternoon, going to the candidates debate. Laugh about it, shout about it when you've got to choose. Everyway you look at it, you lose! Where have you gone Joe Dimaggio? Our nation turns
2002 BMW M3 SMG Convertible
By NikoFab,
Well guys, we were looking for a fun car for my wife. We flirted with a few different ideas but then this baby landed right in my lap. She's in great condition inside and out. Only 89000 miles with the 100K service already performed...pretty good for an eleven year old car. Tires are brand new (still have the inventory print on them), The Harmon Kardon sound system has been upgraded with a Rockford Fosgate powering an Alchemy Air 12" sub, and it has quite a few other bells and whistles. T
ignition system parts and part numbers
By 88-cnqst-tsi,
i just finished putting in a new ignition system and these are the pars i used and tips when installing 1.MSD Blaster 2 coil part# 8203, i had the bend the stock coil holder a bit to fit the blaster in so to bend it back with it still in use a clamp and tighten it as much as possible then get the tension bolt back in. And when installing the resistor bolt it on with the bolt hole on the battery side of the coil and you will have to extend the stock positive wire so dont for get heat shrink 2
