Ok guys wanting to ditch the stock mass what a good one to go with I'm getting ready to go on the dyno and just need to finish up some loose Ends here is a list of the mods so far 19c turbo. Set at 15 lbs 850 & 1150 lsp Injectors adjustable fpr set at 44lbs walbro 255 & 52mm throttle body over size Valves bulit bottom end 2.5 in exhaust no cats the truck ran great in stock form No problems at all and runs great now but going for max hp power with this set up And I'm thinking the stock

here, finally i have one Starion too, iam a Mitsu lover, this is my 11Mitsubishi lot of them are old, but very rare , iam from Zagreb, Croatia, small country near Italy ana Hungary   so, i found this car in some village, its in pretty bad shape, but still runs, i paid for it 450$ engine is 2.0Turbo Eci Turbo with 2injectors on the top, 170hp flatty intercooled version, but has KKK turbine on it EX - luxury equipt A/C ABS power steering vented front and rear discs Turbo rear lip Vestatec Turbo

I need all the pieces for a 5speed swap. So far I have a clutch, flywheel, transmission, driveshaft, interior trim.   I need the clutch master bracket and bolts, the clutch reservoir, any lines, the fork dust boot, the trans tunnel boot, and the pedals.   The bracket that the clutch pedal attaches to is also sweet if you can drill off the tac welds.  

I have a few extra large and x-large shirts if anyone wants one. Graphics are silver on a black shirt.   $17 shipped or 2 for $30   Hope to see everyone at the IDRC Sport Compact Nationals in Norwalk next month! After last years disastrous season, I can't wait to get the car back down the track.   Joe