It's red with no cracks on plastic or glasses still have the rubber weather piece and the bolt 45 bucks shipped

hey guys   I am working on a new project, some of you might remeber me from the TPS sensor upgrades. Well I am at it again, looking for some upgrades for my truck.   Little background is i dont actually have a starion cause they never came to canada but i have a 2.6 equiped ram50 that i starion tbi swapped and megasquirted.   Now I have a idea that is plausible at least for my truck cause i have decent tbi to hood clearance.   I am working on making a 60mm tbi unit, now at the moment its just o

When i drained the old fluid from the transmission and filled with new 75w/90 i noticed a spot of fresh tranny oil right below the rear seal of the transmission where it meets the driveshaft. How hard is it to change this seal? Just unbolt the driveshaft from the torque tube and drop the driveshaft and the seal is there? I found a seal online, timken part number 223608, is this the correct part? Any help is appreciated.

I got this wh1c from a guy to run on a datsun but ended up using a turbonetics i got for cheap. It has a perfect billet compressor wheel and housing and good chra but the bad was the half a piston that was ran thru the turbine. 200.00 + ship for the compressor and chra if you want the turbine its a 12cm divided t3 flange and actuator i will throw it in for free. I heated it hot enough to pour out the piston so its aluminized inside. a new shaft and rebuild kit this will make someone a good turbo