*EDIT* Looking primarily for the fuel pickup tube piece!   I have one right now that just isn't cutting it, and I'm looking to swap it out. I'm not concerned about surface rust, but I don't need anything completely pitted like mine is . Not sure if there's a difference on early cars vs late, so anything 87 or newer, I can use. Thanks!

i would like to test my pressure sensor, i bought it used on here forever ago. i have a 2jz swapped car. and i am working on getting all the factory dash stuff working (for my personal likes of it, not for perfection)   i know if i ground the wire the gauge works, so i know the cluster/wiring is good, which leads me to beileve sensor is bad, does anyone know how to test ( aka maybe put small pressure and read ohms thru it as i slowly increase pressure say from 10-40psi or somethign     second, i

We got lucky here, but 45 minutes north of us wasn't so lucky. Some of these pics were from there.   http://www.breaking911.com/breaking-tornado-damage-in-pekin-illinois-numerous-tornadoes-predicted-to-hit-injuries-reported/

Like the topic says, i have a used centerforce dual friction clutch for sale, i have had it along time, came outta a car that spun a rod bearing shortly after putting clutch in, maybe 5k miles on clutch. i have long parted out everything else i had from this, and actually had forgotten i even had this laying around   it is a 87, i am pretty sure it was the smaller spline setup (remind me its been along time since i messed with the stock parts)   have any questions feel free to ask   200 bucks s