Jump to content

    Indy's Rebuild -- Pistons

    indy_85stariones
    By indy_85stariones,
    I am looking to have quicker throttle response.  I am planning to increase engine compression from 7.0:1, by using 8.0:1 pistons.     I will be using my original ECU.  Will this affect smoothness of idle?  Will this cause my engine to run lean while running under boost?  Is there any negatives when increasing engine compression?  

    Indy's Rebuild -- Gasket Set

    indy_85stariones
    By indy_85stariones,
    Indy's Rebuild -- Gasket Set   I met with a machinist this morning to start discussing my engine rebuild.  Looking thru my notes I suggested the following gasket combo... FelPro head gasket set -- HS9116PT OEM oil pump gasket OEM rear main seal gasket OEM timing chain case side (2) gaskets OEM intake manifold gasket OEM exhaust manifold gasket   He prefers  Victor Reinz over FelPro. http://www.victorreinz.com/ http://users.starpower.net/mtech/fuel_inje...ialties_003.htm   What is ever

    Poly sway bar bushing

    Todd
    By Todd,
    Does any one have a part number for the front sway bar bushing in poly or is there an off the shelf bushing that work.   Todd

    w00

    tux
    By tux,
    well i scored a free 65mm tb from a ford ranger (6 cyl 4 liter) while helping my friend clean his condo so i can live there w/ my woman otherwise we'd be homeless hehe ;D   and i got a place to stay for relatively cheap and a throttlebody! w00t also met a guy around the corner w/ a sweet a** wrx   anyways i also got 6  16 or 18 lb injectors from the car.  (it's not stock tb or injectors)   but the question here is  does anyone know what throttle cable part number i can use w/ the FORD TB (it

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...