Sold.,

Installation of BSEK went ok. While I had the oil pump removed I inspected the gears, cover for wear, relief plunger and spring. I noticed the spring was a little worn and measured under spec. I installed a new spring and made sure relief plunger slid properly. Got it together about an hour ago, cranked the engine a few times to prime, and then fired it up. I noticed right off the bat I had no oil pressure so I shut it down. While I had the pan off I cleaned the pick up tube screen and what litt

Here is a turbine housing in stock size tdo5 (can of course be machined to tdo5h)   It has the surface decked to decrease the distance from the exhaust valve and help decrease the internal volume on the manifold and turbine snail...Here is a comparison... http://i1187.photobucket.com/albums/z388/starionkiller/parts%20for%20sale/th_SAM_2867.jpg http://i1187.photobucket.com/albums/z388/starionkiller/parts%20for%20sale/th_SAM_2860.jpg   The turbine inlet has been ported... http://i1187.photobucket.

http://www.ebay.com/itm/251505401260?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2648