Ok so this guy on craigslist has a complete 2.6 mitsu motor but disassembled. It has a 3 valve head 2 exhaust valves and 1 big intake valve,,,, bigger than our intake valve and the exhaust valves are close to our valve size. Anyways he doesnt know what the motor came from but id just like to know what its from and if this head would work on our motors. The intake manifold side is exact to ours as i tried an extra intake and everything lines up. The exhaust side is not like ours for manifold thou

Well I got my 86 station last week.I flew out to St Louis and drove it back to Colorado.the car has 59k and in really good condition. It was kinda a impulse buy but I really wanted it.I have another sports car but have put too many Miles on it + it has no heat.....I found this one on bring a trailer. Anyway s thanks for having me!   To do list Install new injection connectors Oil pan gasket\front crank seal Clean intake\throttle body\injectors Inspect \diagnosis drive line clunk "torque tube mou

Was on BAT - only 30k on the clock!   http://raleigh.craigslist.org/cto/4734321577.html

I'm hoping someone has a cv shaft laying out that they can throw a tape measure on and get a rough length. Doesn't have to be precise. I would measure my spare but it's buried behind alot of stuff in the cubby hole under the water heater.   The reason I need the measurement is I have an old vietnam era 50 cal night vision scope case. It may be the perfect size to put a pair of CV shafts and spare parts in for long trips. Sadly the scope is long gone.     http://i463.photobucket.com/albums/qq