- 14 replies
- 1292 views
- Add Reply
- 4 replies
- 520 views
- Add Reply
- 7 replies
- 676 views
- Add Reply
- 61 replies
- 5113 views
- Add Reply
Mustang Cobra Big Brake Kit (complete)
By Convette,
Selling my brake setup. I just pulled them off the car last night. This is the FULL BOLT ON setup. Polished PBR calipers, 4 sets of pads (all very usable) 2 sets of hawk blacks race pads ($200 each) 1 set of raybestos race pads ($200) and a set of stock street PBR's, with steel braided lines and all hardware! The calipers were just rebuilt 2 track days ago with brand new seals. (seals are easily replaceable and cost about $5 for both sides.) Brand new rotors have 2 track days on them. (le
opinions on gauge choices needed?
By 88351wtsi,
looking to add a wideband looking at 2 different ones recommendations? Part# 3796 / RED KIT The Innovate Motorsports DB gauges are 52mm (2 1/16”) air fuel gauges. Each gauge features a bright LED (available in blue or red), and retails for $229. Each kit includes the gauge, an LC-1 wideband controller, oxygen sensor & bung/plug, and the award-winning LogWorks engine-tuning software. Key benefits of the “DB” kits include: The industry’s most accurate and fastest-responding wi
Need a transmission
By 86munster,
I need a transmission for my 86 starion, the closer to eastern ct the better, have cash in hand and willing to pick up if close enough thanks brian
Engine not firing
By gribbs1469,
Ok ya'll I have a problem and i can't figure it out.I have a 1987 all stock widebody. I just rebuild the motor and installed it, hooked up all the lines, wires, etc. I have spark, I have fuel now I had to change the pump. checked the injectors, primary is firing. Checked and rechecked timing. The last thing i did was pulled the TB off the intake and there was a puddle of fuel in there. it was actually covering the whole bottom of the intake about a half inch deep. I had pulled the plugs about 10
