Bruno

hey guys having idling problems on my cold start so i was wondering if someone has done a 4g63swap using sds em4 f i would greatly appreciate a few posted maps to point me in the right direction thanks

im having a little problem on cold start idle,at 1000 rpm she dies but if i give it a little more fuel she goes to 1250 to 750 bouncing back and fourth wont stay steady. dont mean to impose on anyones tuning on this lol but im cornered here thanks for even looking

hey guys i have a little problem, i have an 88 auto without reverse lights. new bulbs, i checked for power afterwards in reverse "nothing" is there a relay for it, a sensor in the tranny that sends a signal, any opinion would be nice about now thanks

oh noooooooooooooooooo,u better have a days worth of PERKS for u and ur assistan if go through it , good luck " MAY THE PATIENCE BE WITH U " :starwars:

come on shelby think positive lol hahahaha, well afer work 2day i took the plugs out and poured sum mystery oil in each cylinder gonna wait til saturday then try rokin it and then lft the rear up and do what brazil boy said. thanks for ur advice shelby,ulrichwolf,and brazilboy

ok here's the story i bought a 88 tsi for a few bucks so i can use that motor for my 89tsi. the owner had it sitting outside for about 17 months.without starting it, he said there was nothing wrong with the engine when he last drove it . im thinkn its stuck some how, i put a breaker bar on the on the crank with an xtension and could not turn the it only the bolt turned i so topped cuz i do not want to snap that bolt, if it was a standard i could put it 1st hook a chain to my truck and try breaking it free but its an AUTO unless it would work if the gear is in DRIVE is the tourque convertter stuck, PLEAS ANYONE give me sum ideas besides the motor bein seized lol thanks for ur time and opinion!!!

its not the size that counts matt its how the welds hold up at 28psi lmao but by the looks of it seems like really good welds to me, great job on that !!!!!!!! VERY VERY VERY GOOD WELDER U GOT THERE ide give him a raise also y dont u post that pic of the welder strattling as he welds lmao haha