Chad Posted May 2, 2002 Report Share Posted May 2, 2002 www.geocities.com/my86tsi/intakeprojects.html there's a lot of info at the bottom of the site about cost and options etc. Link to comment Share on other sites More sharing options...
Joel Posted May 3, 2002 Report Share Posted May 3, 2002 www.geocities.com/my86tsi/intakeprojects.html there's a lot of info at the bottom of the site about cost and options etc. Been curious about this for a while... On the square flanged units, how do you seal up where the fuel pump block off plate is on the head? Joel Link to comment Share on other sites More sharing options...
Chad Posted May 3, 2002 Report Share Posted May 3, 2002 you apply a thin coat of gasket glue on a new block-off gasket and stick it to the head over the hole so it stays in place. then you just slide on the intake gasket and slide on the intake. the intake flange sits high enough to completely cover that hole (by design). Link to comment Share on other sites More sharing options...
starion0352 Posted March 3, 2007 Report Share Posted March 3, 2007 www.geocities.com/my86tsi/intakeprojects.html there's a lot of info at the bottom of the site about cost and options etc. haent seen this in a while! i like the velocity stacks! Link to comment Share on other sites More sharing options...
Indiana Posted March 6, 2007 Report Share Posted March 6, 2007 Do you need the stand alone/extra injectors unit to reach 12's????NO! Link to comment Share on other sites More sharing options...
Recommended Posts