losisonq Posted October 28, 2008 Report Share Posted October 28, 2008 installed a new output shaft seal of which the old one didn't look that bad and it still leaks. Oil is being slung out on the driveshaft tunnel in only a few miles of driving. What am I missing? TIA :confused0024: Link to comment Share on other sites More sharing options...
scooterh72 Posted October 28, 2008 Report Share Posted October 28, 2008 installed a new output shaft seal of which the old one didn't look that bad and it still leaks. Oil is being slung out on the driveshaft tunnel in only a few miles of driving. What am I missing? TIA :confused0024: I am in the same dilema with the front pump seal. I would check the end of the drive shaft for wear on the shaft. Probably a groove worn into it causing the seal to leak. I think my torque converter has the same issue that you are seeing. At least yours is a little easier to change than mine. Link to comment Share on other sites More sharing options...
losisonq Posted November 4, 2008 Author Report Share Posted November 4, 2008 Nobody else had this problem? A link to something simular? Link to comment Share on other sites More sharing options...
Recommended Posts