boostandmuscle Posted April 11, 2008 Report Share Posted April 11, 2008 Will megasquirt V 1 with a 2.2 board be able to setup on TBI??? reason i ask is i am getting one for free and curious if i could set it up on my TBI car? any good vs bad things about it?? Link to comment Share on other sites More sharing options...
Too Deep Posted April 12, 2008 Report Share Posted April 12, 2008 (edited) Yes. I ran mine for a year on the TBI before switching to 4 injectors. Actually i started with just MS V1 and upgraded the to the MSII chip just before going MPI. I was using the - coil for rpm input at first but always had a drop signal problem around 3k rpm. I installed an MSD and used the squarewave output for RPM and never had a problem since. Edited April 12, 2008 by Too Deep Link to comment Share on other sites More sharing options...
importwarrior Posted April 12, 2008 Report Share Posted April 12, 2008 so your running a MS2 with the 2.2 board? or did you get the 3.0 board? Link to comment Share on other sites More sharing options...
Too Deep Posted April 13, 2008 Report Share Posted April 13, 2008 so your running a MS2 with the 2.2 board? or did you get the 3.0 board? 2.2 board. The 3.0 wasn't out yet. The upgrade from MS1 to MSII was just replacing the IC chip and reflashing. Also on the TBI i used the stock injector resistors that are behind the passenger side headlight. Link to comment Share on other sites More sharing options...
Recommended Posts