brattesani Posted April 6, 2008 Report Share Posted April 6, 2008 my clutch pedal has no resistance when you push it down and when it comes back it catches about halfway and you have to actually pull it back into place. hopefully it just needs to be bled because there is air in the system? to bleed the clutch, i found a what looks like a bleeder valve on the slave cylinder on the trans, is that where you bleed it from? any help appreciated thanks. Link to comment Share on other sites More sharing options...
boostandmuscle Posted April 6, 2008 Report Share Posted April 6, 2008 have someone in the car push down the clutch pedal to the floor, than open that bleeder screwed on the slave cylinder, push the rod all the way into the slave cylinder by hand, tighten the screw,, have your friend take his foot off the clutch and pull it up.. repeat the proccess... by pushing that rod into the clutch slave cylinder when he has it fully extended it pushs any air out.. Link to comment Share on other sites More sharing options...
Wolf87Conquest Posted April 6, 2008 Report Share Posted April 6, 2008 There shouldn't be air in the clutch hydraulics unless you've worked on it or the fluid level is really low due to a leak. Resivour full, pretty much says the clutch master or slave needs rebuilt. To bleed the system, yes, the bleeder is on the slave cylinnder. The fluid in it is brake fluid...use DOT 3 or above. Link to comment Share on other sites More sharing options...
brattesani Posted April 6, 2008 Author Report Share Posted April 6, 2008 bled the system, problem went away, but it looks like the master needs to be rebuilt probably. sigh. Link to comment Share on other sites More sharing options...
Recommended Posts