Josh '88 Posted November 25, 2003 Report Share Posted November 25, 2003 Here's some pictures showing how to "clear out" Starquest taillights. Picture of the lense cover removed from the taillight assembly: Picture of the lense cover from the rear: Picture of the taillight assembly with the red lenses removed: Picture of the taillight asembly with the back-up lense installed: Picture of the lense cover installed on the clear taillight. Also, a comparison to the OEM taillight: Picture of the taillights installed on my Quest: If you have any questions, please let me know. Josh Link to comment Share on other sites More sharing options...
Ryan_V Posted November 30, 2003 Report Share Posted November 30, 2003 8) Looks fantastic thanks for the pics I was wondering how the red lense removal happened Link to comment Share on other sites More sharing options...
stariongirl Posted December 7, 2003 Report Share Posted December 7, 2003 hey cool! i found some bulbs i want to use from APC they are at g.i. joes sports and auto store for $10.00 each. they are called Titan bulbs an they look like chrome but light up red or amber.so pretty much cant see 'em in there they match the reflectors. s/g Link to comment Share on other sites More sharing options...
SHhhhh Posted December 8, 2003 Report Share Posted December 8, 2003 Here's some pictures showing how to "clear out" Starquest taillights. They look great. If it is not too much trouble, could you please post more pics of the back of your car with the taillight mod? Thanks! Link to comment Share on other sites More sharing options...
Josh '88 Posted December 8, 2003 Author Report Share Posted December 8, 2003 SHhhhh: Are you refering to my brake/turn signal mod? If so, click here: http://www.starquestclub.com/index.pl?boar...;num=1069724939 Josh Link to comment Share on other sites More sharing options...
lookin4starquest Posted December 16, 2003 Report Share Posted December 16, 2003 Nice..but how do you get the outer (ribbed) cover off ?? Link to comment Share on other sites More sharing options...
D_Venable Posted December 16, 2003 Report Share Posted December 16, 2003 You have to heat up the factory glue holding them on, and then gently pry them off. There are a few ways to go about about doing this though: - Oven (350* for 5 min, or somethiing like that, not sure) - hot water (takes a long time but less prone to warp outer clear lense) - and heat gun. Derek Link to comment Share on other sites More sharing options...
Recommended Posts