OutcastZeroOne Posted May 10 Report Share Posted May 10 Hey guys, been a few years. Right now I am in a bit of planning stages for a potential project. Currently I work at Zero Motorcycles as part of the Motors In House team building motors for the new DSR/X we are making. This 65 lbs electric motor is a bit of a beast. 110hp, 175 ft/lbs of torque. I am toying with the idea of converting my G54B powered Ram 50 to electric and there are a few programs at work for this, though I have one small snag. I am in need of measurements of the bolt pattern and in relation to the input shaft center of the transmission. I am so far unable to find anything on actual diagrams for this. I also have the factory manual for my truck and for my Conquest but neither have any information or measurements on this. Any help is greatly appreciated. Link to comment Share on other sites More sharing options...
obsolete Posted May 10 Report Share Posted May 10 I have a transmission out of a car and a 6" digital caliper. How accurate do the measurements need to be? Link to comment Share on other sites More sharing options...
OutcastZeroOne Posted May 10 Author Report Share Posted May 10 6" caliper might be too small, but for now a rough idea of things would be a massive help Link to comment Share on other sites More sharing options...
obsolete Posted Thursday at 01:14 PM Report Share Posted Thursday at 01:14 PM I was just thinking about this, you know who I'm sure has an accurate Mitsubishi wideblock bellhousing drawing? Bill Hincher: https://www.billsautofab.com/projects/ He makes all sorts of adapters. Maybe he'd be willing to work with you. Link to comment Share on other sites More sharing options...
Recommended Posts