Jump to content

Hard start need help-- 3.4 ohms on clip not injector (on inj 2.2)


money4771
 Share

Recommended Posts

It shouldn't start at all with the primary unhooked. The secondary doesn't hit till 2500 RPM.

 

Do you have the right clips plugged into the right injectors, and do you have the injectors in the proper orientation?

 

Tim

 

that is what i was thinking. but mine both have aftermarket clips. It doesn't matter which one is hooked up it will start just the same and won't idle well either way really especially cold but really bad with just the primary injector plugged up or the secondary injector being used as primary. only idles acceptably with both clips plugged up. wt?????

Link to comment
Share on other sites

also it doesn't idle well. I know that the resistance on the cts shows 3700 and is bad but it does warm up and show 290. even using a 300 ohm resistor in its place doesnt make it idle that much better. when it warms up it idles at about 1500 rpm. it will not idle at 900-1200 or it dies every time. even when i can get it to idle steadily at 1500 rpm it will try and die at almost every stop unless i goose it a little.

 

it idles at like 10.9 on the wideband

Link to comment
Share on other sites

You may have crudded up injectors, Send them out to get 'em flow tested and cleaned. Most diesel engine repair shops can do this for you or you can send them to Witch Hunters.

 

http://www.witchhunter.com/injectorfaq1.php4 - I've been using this outfit for the past 8 or so years and they do good work.

 

http://www.witchhunter.com/injectorfaq1.php4#what2 Read this - it looks like your symptoms are noted here.

 

For What It's Worth.

 

KEN

Link to comment
Share on other sites

 Share

×
×
  • Create New...