car has no power while driving

[Snowman3karrotz]

1st off sorry for reposing this is the other mechanic areas its just ive tried a lot and nothing seems to work.

 

 

 

when i take off, its not taking off like it suppose to.

 

when im driving it, if i floor it, it wont shoot off like it suppose to

 

its like i have no power.

 

any ideas on what i can mess with to fix it?

 

thanks in adv..

[importwarrior]

start easy, verify and or reset the TPS and ISC MPS sensors.

if all is good then check timing. make sure it is set properly.

 

if still not fixed. i would swap the MAF sensor. that was my problem.

i had not power. cleaned all the contacts on the maf. then cleaned

the harness end of the maf sensor connector. i actually got welder

tip cleaner from harbor freight for like 6 dollars. they were small

enough to get in to the harness maf sensor connector contacts and

not stretch the contacts.

 

next check the injector contacts. clean them with a nail file emery board.

i used my girlfriends.

 

check the wastegate actuator arm. where it connects to the flapper on the

turbine side of the turbo. once the cotter pin fell or rusted off. i used

a paper clip to replace it.

 

well hope that helps a little. or at least it is a starting point.

[Snowman3karrotz]

start easy, verify and or reset the TPS and ISC MPS sensors.

if all is good then check timing. make sure it is set properly.

 

if still not fixed. i would swap the MAF sensor. that was my problem.

i had not power. cleaned all the contacts on the maf. then cleaned

the harness end of the maf sensor connector. i actually got welder

tip cleaner from harbor freight for like 6 dollars. they were small

enough to get in to the harness maf sensor connector contacts and

not stretch the contacts.

 

next check the injector contacts. clean them with a nail file emery board.

i used my girlfriends.

 

check the wastegate actuator arm. where it connects to the flapper on the

turbine side of the turbo. once the cotter pin fell or rusted off. i used

a paper clip to replace it.

 

well hope that helps a little. or at least it is a starting point.

 

 

O MAN, I REALLY APPRECIATE THIS... IT SHOULD KEEP ME BUSY FOR THE NIGHT..... ILL LET YOU KNOW WHAT HAPPENS IN THE MOURNING

[Shelby]

i bet theres at least 400 threads on this very thing,,what makes you think nothing in any of them applys to your car,,,they are all the same car

not trying to be smart tail, but a little reading of back pages in the Vmech and adv mech forums can give you insight into every thing you may need to test or check

[importwarrior]

and maybe even the fix!

[Snowman3karrotz]

i bet theres at least 400 threads on this very thing,,what makes you think nothing in any of them applys to your car,,,they are all the same car

not trying to be smart tail, but a little reading of back pages in the Vmech and adv mech forums can give you insight into every thing you may need to test or check

 

thats what i did the 1st day i worked on it. i went through all the postings and s*** and couldnt find anything