Djchunter Posted June 11, 2010 Report Share Posted June 11, 2010 (edited) Built engine: All machine work done by general engine rebuilding in cleveland, Well known local Mitsu guy Wiseco forged pistons .030 over Shot peened and re-sized rods Clevite bearings Balance shaft removal Computer balanced rotating assembly (crank cut .010 on rods) Fitted Crank scraper (not installed) Ported and polished Marnel head (by Box Performance out of West Lake ohio) 284 schneider solid lifter cam Shnieder springs and retainers 1mm oversized stainless valves swirl polished and undercut stems 5angle valve job Aajusa mls head gasket ARP studs throughout the entire engine 88 flywheel and trans ACT 2600 6 puck clutch Short throw shifter Custom RC engineering injectors 680 primary and 1200 secondary Treadstone cast t3 manifold flanged for .38mm wastegate This motor was professional installed but Auto Techs in Maple heights Ohio and the motor was assembled along with all machine work by General engine rebuilding of Cleveland Ohio. The head was done by Box performance out of Westlake Ohio. The motor doesn't even have 500 miles on it, still in the break in phase before it was put away for the winter. Finally going the 4g route so my loss is your gain. Motor will be complete from injectors to pan including the flywheel, clutch, and trans. Add your turbo/wastegate and IC set-up and your ready to go! I am looking for local pick up but if shipping is needed I will help as long as the buyer sets it up. Motor is still in the car currently and can be heard run. I can be reached anytime at 440-342-2412, if I don't answer please leave a message.Asking $2800 http://img.photobucket.com/albums/v650/DJChunter/2.jpghttp://img.photobucket.com/albums/v650/DJChunter/1.jpg Edited June 18, 2010 by Djchunter Quote Link to comment Share on other sites More sharing options...
Djchunter Posted June 11, 2010 Author Report Share Posted June 11, 2010 (edited) Forgot to mention that this will also include the MSD digital 6 ignition box, msd coil, and the Taylor plug wires. ThanksDave Edited June 18, 2010 by Djchunter Quote Link to comment Share on other sites More sharing options...
Djchunter Posted June 18, 2010 Author Report Share Posted June 18, 2010 I have been driving the car everyday for the last week and put roughly another 350 miles on it. Open to offers/trades. ThanksDave P.S. This is roughly half of my investment price, Save! Quote Link to comment Share on other sites More sharing options...
Wizard Posted June 18, 2010 Report Share Posted June 18, 2010 Would you sell just the motor? Quote Link to comment Share on other sites More sharing options...
Djchunter Posted June 19, 2010 Author Report Share Posted June 19, 2010 Would you sell just the motor?For the right price I would think about it. PM me what your thinking.Dave Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.