JohnnyWadd Posted June 3, 2014 Report Share Posted June 3, 2014 (edited) http://i1187.photobucket.com/albums/z388/starionkiller/idler%20arm%20fix/th_SAM_4491.jpg http://i1187.photobucket.com/albums/z388/starionkiller/idler%20arm%20fix/th_SAM_4490.jpg http://i1187.photobucket.com/albums/z388/starionkiller/idler%20arm%20fix/th_SAM_4489.jpg This is a moog idle arm kit in a 1998 flatty idle arm, K9100 Moog Idler Arm Bushing. Some have said the flatty bushing will not work or is different... http://www.starquest...er#entry1374871 http://www.starquest...er#entry1326056 But.....That is not true. It works fine. This is my third install. See video too. Edited April 9, 2015 by JohnnyWadd Link to comment Share on other sites More sharing options...
natallica Posted June 3, 2014 Report Share Posted June 3, 2014 video is "private" -N8 Link to comment Share on other sites More sharing options...
importwarrior Posted June 3, 2014 Report Share Posted June 3, 2014 have a part number for the seals? Link to comment Share on other sites More sharing options...
JohnnyWadd Posted June 3, 2014 Author Report Share Posted June 3, 2014 (edited) video is "private" -N8 Fixing now sorry have a part number for the seals? This is a moog idle arm kit in a 1998 flatty idle arm, K9100 Moog Idler Arm Bushing Not sure about the "seal" ...are you meaning the old 1998 one? Edited June 3, 2014 by JohnnyWadd Link to comment Share on other sites More sharing options...
IntercooledFlatty Posted June 3, 2014 Report Share Posted June 3, 2014 getting ready to do one of these and pretty sure they are all the same like JW posted Link to comment Share on other sites More sharing options...
JohnnyWadd Posted June 3, 2014 Author Report Share Posted June 3, 2014 getting ready to do one of these and pretty sure they are all the same like JW posted If you grab the Noltec Poly ones they are a little different on the lip part. The inner and outer diameters are same though. Link to comment Share on other sites More sharing options...
importwarrior Posted June 3, 2014 Report Share Posted June 3, 2014 (edited) in this pic you have a seal laying on the bench.i was wondering if that is needed for the rebuild? http://i1187.photobucket.com/albums/z388/starionkiller/idler%20arm%20fix/SAM_4490.jpg Edited June 3, 2014 by importwarrior Link to comment Share on other sites More sharing options...
JohnnyWadd Posted June 4, 2014 Author Report Share Posted June 4, 2014 in this pic you have a seal laying on the bench.i was wondering if that is needed for the rebuild? http://i1187.photobucket.com/albums/z388/starionkiller/idler%20arm%20fix/SAM_4490.jpg Its not used, its just part of the old two piece bushing. Now you could trim the new bushing with an exacto type blade, and reuse this piece. But the lip on the new bushing seals it up nicely. Link to comment Share on other sites More sharing options...
Recommended Posts