Jump to content

Rev383

Members
  • Posts

    17
  • Joined

  • Last visited

  • Days Won

    1

Rev383 last won the day on July 7

Rev383 had the most liked content!

Profile Information

  • Location
    VA

Previous Fields

  • Zip Code
    24133
  • Model Year
    1986

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Rev383's Achievements

Apprentice

Apprentice (3/14)

  • Collaborator Rare
  • Dedicated Rare
  • One Month Later Rare
  • First Post Rare
  • Conversation Starter Rare

Recent Badges

2

Reputation

  1. I figured it out thank you all. I broke the solenoid nipple when I was redoing my hoses found the upper side had a weird valve I think it’s a reefs valve. It was messed up couldn’t blow or suck through so I vented it atmosphere. It runs so much better full boost no hiccups for now.
  2. The three nipple one going to the map sensor and it’s next to the map sensor. I’m wanting to simplify the vacuum hoses and seems like that can be deleted but it did causing idling issues for my car. I did not cap them I ran the intake to the map sensor and it ran great but wanted to die at idle
  3. Are the boost solenoids important on these cars?
  4. Is there a way to lube the throw out bearing without taking the transmission out?
  5. Never mind I am just dumb and didn't look at the manual
  6. I'm looking to replace my entire steering and bearings upfront, but i can't seem to find the upper ball joints does anyone know what will fit it.
  7. I regapped the plugs to 0.28 and burped the coolant system. So far fingers crossed no bucking at all. The plugs were a touch on the lean side but not too bad to worry. I will check the timing when I find my timing light. My car has a aftermarket radiator system in it
  8. What is the proper coolant bleeding procedure and does it have coolant bleed screw? I’ve looked everywhere I can’t find anything on it.
  9. I gapped the plugs to .035 I’m wondering if I need to go lower to like a .028 I had a eagle talon that loved that gap
  10. Okay so I've been putting miles on my Conquest it just started bucking when the car gets warm the secondary fan does not come on but the car doesn't go past half way and i'm not sure if the temp gauge is right. The radiator is upgraded with a thick aluminum radiator but you can't put your hand on it. If i can get pointed in the right direction that could help me , I've got a fuel filter on order i may swap the fuel pump my thoughts is maybe the pump is getting hot and fuel pressure is dipping. Car is on stock boost pressure 7 pounds. it only does it under full boost.
  11. Thank you very much, but I don’t have half of these anymore and what port should the BOV hook too
  12. Does anyone have a picture of where all the vacuum hoses are supposed to go. I have looked at all the faqs and none of the links will work for me. I’m just wanting to double check my work
  13. I’m not sure about the reverse lights. It was a project car of a buddies. We built it with some friends in college (15 years ago) he needed to find it a home so now I have it. I’m getting it road worthy and correcting a few things. It was last inspected in 09. It had an accident we put a new front end on it and built the motor.
  14. Okay so they don’t stay on. These fuse panel I’m looking for is under the antenna cancel button. If that’s right the fuse is good! Also I have power to the back up switch plug.
×
×
  • Create New...