Just curious why my radio does'nt work but the tape and eq and all steering wheel controls work but the radio does'nt light up and if you switch it to the radio there is no static . It is a factory setup in an 86 esi-r. ???

I know youve probably seen these  before and I dont want to piss the owner off but I just think these are the best looking quest rims ever.http://www.cardomain.com/memberpage/652135 If the owner is a member here Id like to hear more about them.

These switches can be cleaned and the belts will normally work afterwards. The front one is located behind the A-pillar cover, the back one behind the side cover next to the rear seat. You can take them out, use electrical cleaner on the pieces, di-electric grease, and re-assemble. Here are a few pics:   The front connector:   http://img355.imageshack.us/img355/2137/seatbeltlimitswitch3tk6.jpg   The pieces to take out and clean up:   http://img355.imageshack.us/img355/4564/seatbeltlimitswitch2

I finally got a set of MR2 struts (KBY AGX #765016) and a new set of strut insulators so that I could start installing Art's kit. I figured I'd start easy and do the fronts first. As far as coil overs I'm using a set of Ground Controls w/ 550lbs/in. Eibach springs up front.   It's pretty straight forward. I pulled the strut assembly off. Nothing too complicated, although I did have a little trouble removing the assembly from the knuckle. It had rusted, but soaking it in PB Blaster for a few hour