tsiman Posted April 28, 2004 Report Share Posted April 28, 2004 Hey i pulled off my fog lights and when i took out the bulbs there was a lot of corrosive white stuff all over. What do you guys think would be best to clean these contact points? Thnx Kev Link to comment Share on other sites More sharing options...
JustPaus_88TSi Posted April 28, 2004 Report Share Posted April 28, 2004 Make a solution of baking soda and water... Put about 5-6 spoonfuls into a cup, add water and stir, then drop in the bulb... If you need a little more kick, substitute water with vinegar... Lemon juice is nice too... Link to comment Share on other sites More sharing options...
tsiman Posted April 29, 2004 Author Report Share Posted April 29, 2004 What about for the fog light assembly itself.....and the contact. Because my fog lights are not working at all now. How does the fog light connect.....from the light itself to the Red wire from the harness....then the black wire from harness to the Contact from the bulb holder? And also what button in the car turns them on....maybe i just dont have the right button pushed in ??? Link to comment Share on other sites More sharing options...
JustPaus_88TSi Posted April 29, 2004 Report Share Posted April 29, 2004 I'm not sure about the wires behind the unit, it's been awhile since mine were out.. But the button is the middle one in the right hand switch cluster... Link to comment Share on other sites More sharing options...
charlie31603 Posted May 12, 2004 Report Share Posted May 12, 2004 I'm having the same problem with mine. I just took a file to the contacts and then replaced the conectors on the black wires. Then only one of them worked, so I tried puting a test lite on the one that didnt work and blew somthing now none of them work! : Link to comment Share on other sites More sharing options...
Guest c89zx7r Posted June 10, 2004 Report Share Posted June 10, 2004 put a new foglight fuse in it . take out battery . take both black panels off that is in between the battery and the drivers side fender . top and side panel . under a black lid about 1 inch by 2 inchs there is a fuse for the foglights Link to comment Share on other sites More sharing options...
Recommended Posts