I was changing the oil in the Quest this weekend and I noticed my wiring in the knock sensor harness plug was (I believe) incorrect. It looks like a brown/white stripe (or black/ white stripe) shielded wire with a white wire inside. The PO has the shielded side soldered to one of the pins and the white one soldered to the other pin. I searched through the manual but I couldn't find the proper color codes that corresponded to the plug. However the sensor side has a black wire and a red wire Can someone elaborate on how this is to be wired properly so it works right, and let me know which order they go into the harness plug so that both sides are connected in the correct manner? Also, what symptoms will this cause if it has been hooked up incorrectly? Thanks guys. -N8