Booya

do you know what they do?

I am installing my new Gen II Maft. I have "Standard connections for a 1G DSM" installation wiring diagram that came with the Maft. It shows I need to connect the Purple line from the maft to the "Snsr Gnd Green/black" I dont have this. Also the white line from the Maft go s to "Engine speed/CAS Black" I dont have that. What should i do? I have all the other wires figured out. Any help would be appreciated.

I need Manifold translator and wideband to control my mix. If you got PM me plz.

That s what she said! :iagree:

I got 376 miles be for my cotion light came on. driving around town. what the hell do you all get in a tank? :gamer:

what did you mean by "Then turn over over and over. them fire". did you mean it back fires? by the list of things you did i would guess,,,, -pcv valved removed and replaced with straight fitting -pipe on rear of vc, you can blow air toward open end, cannot blow air toward vc I would start by undoing that, put it back the way it was and see if you might of done something wrong. I bet it is something else. What if any codes are you getting out of your ECU?

thanks guys, I got a good start on what to look for and some prices. Thats what i needed.

what type of upgrade are you thinking? I have a 16g and i am running about 18 pounds.

My friend used to run a fuel controller on his eclipse. it took the mass air reading and changed it, then ran it back to the ecu. that is what i think i looking for.

Stock, 2 inj and 2 clips

all 4 are in good shape. Do you know of any fuel controllers for the StarQuests?

it is a 88

I was looking for a cheap (in price) fuel controller. when i get to about 16 pounds of boost my stock ECU just thows all the fuel at it can. What should i get, and were can i get it?

looking for a 87-89 black dash

I need a !g mass air. you got one or know were i can get one please PM thanks Chris