Leeintheconquest Posted December 22, 2011 Report Share Posted December 22, 2011 Has anyone used a PAC SW1 adapter or any kind of adapter for the steering wheel controls when putting in a new head unit? I'm trying to figure out what wires to use from the factory harness to get the signal to tie into the adaptor. The wires the adapter manual says to use do not match with the factory wiring........... Any help? Link to comment Share on other sites More sharing options...
Leeintheconquest Posted December 22, 2011 Author Report Share Posted December 22, 2011 OK, found the thread about this so sorry for asking again. I would like some clarification as to the Green/White wire from the factory plug: It looks to me like it should be left alone and connected to anything during the install. Is this correct? Link to comment Share on other sites More sharing options...
Recommended Posts