Jump to content


Member Since 02 Apr 2016
Offline Last Active Yesterday, 07:56 PM

Topics I've Started

3 knock boxes and 86 accordion tube w iat sensor

22 April 2019 - 08:40 PM

I have 3 knock boxes for sale.

One is new l used it for about one month on my 87 before going MPI.
The other 2 are used but in good working condition. Small piece of plastic broken at the side of the plug on one of them but it doesn't effect its functionality.

Also have accordion hose/intake from 86 w iat sensor in it.

$100 + shipping for the new 87 knock box(paid 5 times that amount idiot me lol)
$50 a piece for the other 2 used knock boxes+shipping
$35 for the accordion w iat

Part numbers and detailed pictures are below.

miscellaneous  stuff https://imgur.com/a/2IaRbIb

Windshield washer tank w pump and gage project

20 April 2019 - 09:44 AM

Pretty sure someone has done this before but here is my version.
After going mpi l needed  washer fluid tank w pump gage and all.
Already had rear washer tank sitting around that now will be in the front.

Turns out cap from the front tank fits perfectly on rear washer tank filler neck as you will see in pictures.Blue permanent marker does the trick lol.

Next l test fitted the front pump and it fits perfect on the rear tank.

There is a breather nipple on the back of the rear tank. Short hose to route it away and perfect.

Now l needed to mount my stock washer gage sender.
Found a flat spot on bottom and drilled a hole like stock to .940 or so. Pushed the gage sender in and perfect no leaks. Light on dash comes on when tank is down to about 1/4 empty or so.

Just extended all wires to reach and now we can spray again.


Washer fluid tank relocation w gage https://imgur.com/a/kAJxtjc

87 for sale low mile car

15 April 2019 - 07:50 AM


Sweet car

86 boost sensor

04 April 2019 - 06:32 PM

Have one for sale. Make me reasonable offer .
Some pics for you.
Boost sensor 86? https://imgur.com/gallery/LPcaS0G


In need of torque tube shaft(worn out ok)

10 February 2019 - 07:41 AM

I am working on a project of new spline gears for the torque tube shaft and gear that it mates to on rear end. If anyone has extra torque tube shaft let me know.Need extra one for this project. One w worn out splines is ok.
Thank you