-
Images
- 13 replies
- 1110 views
- Add Reply
- 1 reply
- 689 views
- Add Reply
- 35 replies
- 1942 views
- Add Reply
- 5 replies
- 961 views
- Add Reply
i got one for ya guys
By PDodson,
my friend has a 1987 conquest, valencia gold heres the problem, with the MAS plugged in the car idles fine, but you cannot rev it up with the MAS un plugged the car does not idle, but revs up good..... it has NEW injectors, FPR, ENGINE help us please, this is driving us crazy....
take a look for sale
By carolina_crybaby,
hard pipe's and big intercooler $400.00 plus shipping thanks dran1
Voltage drop in the last 24 hrs
By Munkee,
So my volt meter in the dash usually reads around 12v. This scared me at first until a I took a volt meter and tested voltage at the battery and got around 13.5-14v. Figured the gauge was off. Ran this for a while now. Recently my blinkers stopped flashing. They would blink for a few seconds, then just stay on, hazards worked fine. replaced the flasher w/ an EL-12 unit yesterday. Tested and they seem seem to work fine. Went back out about 2 hours later to replace my wipers. Went to test
High Idel and Surging idel...
By 03CL55AMG,
Well I finally got the quest running, she is running good..however she has a high idel(1300 to 1500 rpms ) and sometimes the idel will surge up and down 1500 to 1000, I have set the TPS and the ISC twice but I can't get it corrected, I have tried adjusting the idel screw and what I mentioned before...any ideas, thanks for the help.
