Leaderboard

Time for another update on the weekend's progress: I think you all probably know that I can't leave things alone, haha. I scuffed up the black epoxy. Some of the filler work I did had pin holes in it (as expected because it was such a quick job), so I used a little glaze putty to fill them. Then reshot with serbia black BC. No clear, for I wanted it to have a more of a satin look to match the rest of the engine compartment. I think it came out good, although I still need to unmask to see how close it really is. I still don't like that corner, but I really need to accept it for what it is...for I'm not going back now. Sprayed the headlight bucket as well, which use to be burgundy. The bracket on the left was bead blasted to bare metal, two coats of epoxy and two coats of BC. The bucket itself was just a quick wipe down and one coat of BC (It's fully hidden but didn't like the burgundy overspray on it) And while I had the spray gun out, I decided to work on my project that was in process prior to the collision..refurishing my spare set of 7/8s. I had these all polished up over the winter but needed the insets painted. I really do wonder if the accident would have ever happened if I had finished this project earlier (with new rear tires on). Really curious to see how these look after removing the tape...I haven't touched them since, just letting the paint cure well.

Its always good to get a health check on a engine before disassembly. I at the minimum would want actual oil pressure readings hot at idle and where the bypass is, compression test and leak down test. You will have 1 or 2 cylinders that will give you poor reading do to the HG blown probably but it will let you know the conditions of the rings, cylinders, valves, jet valves, head if cracked. A few minutes can give you a lot of info.

Was this just for s**** and giggles or are you really looking into a full rebuild over a blown head gasket? X2 what @techboy suggested. To add to cylinder head inspection, look for any hairline cracks in between valves and sparkplug holes.

That response has you rebuilding the bottom end ... cleaning the block and putting in new bearings. If you just had a blown head gasket you could literally just pull the head and leave the block in the car and replace the gasket. Depending on the severity of the situation, of course, but that response is more of a total engine rebuild.