nc_beagle Posted June 12 Report Share Posted June 12 I have the engine out and hanging on a hoist. I'm unsure where to attach the four engine stand "posts" to the engine. Here's the stand: https://a.co/d/0151UHcG. You've seen the engine before. Any suggestions? My mechanic friend is pretty sporadic in his help and I'm about to tackle this whole project by myself (with frequent posts here, most likely.) Link to comment Share on other sites More sharing options...
tux Posted June 13 Report Share Posted June 13 I use the widest bottom bellhousing and the two top bellhousing holes. if you have the flywheel still attached you need to have some spacers 1 Link to comment Share on other sites More sharing options...
admin_JAinsworth Posted June 13 Report Share Posted June 13 Years ago I mounted one from the side of the block. Forgive me for not remembering exactly where I bolted it but this allowed me to connect everthing to the front and rear of the block before re-installing it. Jimmy 1 Link to comment Share on other sites More sharing options...
nc_beagle Posted June 26 Author Report Share Posted June 26 Thanks, guys. I'll report back if I'm successful! 1 Link to comment Share on other sites More sharing options...
Recommended Posts