flatty86 Posted October 8, 2015 Report Share Posted October 8, 2015 Hey Guys, I got ahold of a 87 conquest roller and doing a LS1 swap. I have ben doing a lot of research on the forms and has become very helpful. Currently I'm stuck on the rack & pinion install. Go with the 240 rack but hard to find parts. I will post pictures of build soon and any help is much appreciated. Link to comment Share on other sites More sharing options...
autotr8er2 Posted October 9, 2015 Report Share Posted October 9, 2015 there's a wealth of knowledge and support here. I'm Rooting for you Link to comment Share on other sites More sharing options...
flatty86 Posted October 10, 2015 Author Report Share Posted October 10, 2015 Thanks man...Have done a lot of work so far but i am unable to upload pictures here for some reason.. Link to comment Share on other sites More sharing options...
flatty86 Posted October 10, 2015 Author Report Share Posted October 10, 2015 (edited) http://i667.photobucket.com/albums/vv39/LSQuest/quest23_zpsao5vijjz.jpg Edited October 12, 2015 by flatty86 Link to comment Share on other sites More sharing options...
BuGG Posted October 10, 2015 Report Share Posted October 10, 2015 Right in the newbie introduction page. http://www.starquestclub.com/forum/index.php?showtopic=124421 Link to comment Share on other sites More sharing options...
flatty86 Posted October 12, 2015 Author Report Share Posted October 12, 2015 I'm working in installing a 240 sx rack & pinion. I found a (how to) post on here, but important information is missing. What outer tie rods are you guys using with the 240 rack in order for it to be compatible with the conquest? Link to comment Share on other sites More sharing options...
Turbo Cary Posted October 12, 2015 Report Share Posted October 12, 2015 I believe people were using 300zx inner tie rods that have the be shortened to get proper alignment range Link to comment Share on other sites More sharing options...
Menesing Drifter Posted October 13, 2015 Report Share Posted October 13, 2015 I used 240 outers, got the whole set up from NAPA for cheapies!! Good luck on the build man!! Link to comment Share on other sites More sharing options...
flatty86 Posted October 14, 2015 Author Report Share Posted October 14, 2015 thanks man...What year 240? and how did you get the steering wheel connected? Do you have pictures? Link to comment Share on other sites More sharing options...
Menesing Drifter Posted October 20, 2015 Report Share Posted October 20, 2015 thanks man...What year 240? and how did you get the steering wheel connected? Do you have pictures? It was a 92 I think. Had to make a complete custom steering shaft assembly. Check out my build thread for pictures! Link to comment Share on other sites More sharing options...
Recommended Posts