psu_Crash Posted September 17, 2015 Report Share Posted September 17, 2015 Pulling the pedal out to install some bushings and bearings to tighten things up. How the heck do you get that spring of the clutch pedal? Link to comment Share on other sites More sharing options...
pcristquester Posted September 18, 2015 Report Share Posted September 18, 2015 Haha been there, struggled with that too. There is a bolt that retains a half round bracket on one end Link to comment Share on other sites More sharing options...
psu_Crash Posted September 18, 2015 Author Report Share Posted September 18, 2015 Yeah, I got the bracket off. That didn't do the trick. So I pulled the pivot bolt out and braced for impact lolSorry to report no blood was shed Link to comment Share on other sites More sharing options...
pcristquester Posted September 18, 2015 Report Share Posted September 18, 2015 I can't remember exactly the trick, but I figured it out when doing the second one Link to comment Share on other sites More sharing options...
aknorthstar Posted September 18, 2015 Report Share Posted September 18, 2015 unbolt , slide sidewayshttp://i1321.photobucket.com/albums/u546/cjhippie/album_pic9_zpscho3szji.jpg Link to comment Share on other sites More sharing options...
aknorthstar Posted September 18, 2015 Report Share Posted September 18, 2015 http://i1321.photobucket.com/albums/u546/cjhippie/album_pic5_zpsl27v6c8j.jpg Link to comment Share on other sites More sharing options...
aknorthstar Posted September 18, 2015 Report Share Posted September 18, 2015 http://i1321.photobucket.com/albums/u546/cjhippie/album_pic4_zps3pc7klkd.jpg Link to comment Share on other sites More sharing options...
Recommended Posts