Phitroy007 Posted September 11, 2015 Report Share Posted September 11, 2015 Recently I tried to post this topic and may have upset a few members, I apologize if That's the case. I'm still looking for some directions from anyone who has done this before. Thanks in advance Quote Link to comment Share on other sites More sharing options...
BC_99 Posted September 11, 2015 Report Share Posted September 11, 2015 Try posing future questions in the newbie q&a forum. Feedback forum isnt the right place, but at least it's your own thread this time. Its been awhile since I removed one, but I thought it was just a few screws along the bottom holding it in there. BC_99 Quote Link to comment Share on other sites More sharing options...
speedyquest Posted September 11, 2015 Report Share Posted September 11, 2015 Here is how I remember the removal process, although its been its quite awhile since I've even had a glove box in my car. Open the glovebox and then at the top of the plastic where it meets the openings top push in on the corners a bit. This will allow the glovebox's top to slide out of the "hole" its in. By this point your glovebox should be only attached to the dash by the hinge at the bottom. Just remove the screws and bob's your uncle. I'm sure I didn't describe the first part very well so if you need further direction just let me know and I'll try and reword it. Quote Link to comment Share on other sites More sharing options...
87redcat Posted September 11, 2015 Report Share Posted September 11, 2015 Yeah what speedy said. 3 screws on the hinge I believe. Quote Link to comment Share on other sites More sharing options...
pcristquester Posted September 11, 2015 Report Share Posted September 11, 2015 I think the panel just above where your shins would be has to come off first to expose the glove box hinge screws. Quote Link to comment Share on other sites More sharing options...
importwarrior Posted September 11, 2015 Report Share Posted September 11, 2015 openpress sides in after pressing in the sides pull towards you...it flips down hangs downremove screws. Quote Link to comment Share on other sites More sharing options...
Phitroy007 Posted September 11, 2015 Author Report Share Posted September 11, 2015 Thanks guys, I just didn't want to take the chance and break something as these cars are getting rarer and parts are hard to come by. Greatly appreciated Quote Link to comment Share on other sites More sharing options...
Malykaii Posted September 14, 2015 Report Share Posted September 14, 2015 You definitely don't want to damage the car... But damaging the forum by posting/vandalizing all over the place is cool. Quote Link to comment Share on other sites More sharing options...
techboy Posted September 21, 2015 Report Share Posted September 21, 2015 Just did this yesterday. Here ya go.... 3 screws, should take about a minute to get out. http://imagizer.imageshack.us/v2/800x600q90/673/l0Op43.jpg Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.