Rachet

What are some tips to running the Xtreme pressure plate and Fidanza yet no wrecking your thrust bearings? Things I know: 1. Don't start the car with the clutch pressed. 2. Don't idle at lights with it pressed. 3. Heat up the fidanza before installation. 4. My car has a Balance Shaft delete so higher oil pressure. 5. Not driving until oil is warmed up aka pressure comes down and is steady.

I need all the pieces for a 5speed swap. So far I have a clutch, flywheel, transmission, driveshaft, interior trim. I need the clutch master bracket and bolts, the clutch reservoir, any lines, the fork dust boot, the trans tunnel boot, and the pedals. The bracket that the clutch pedal attaches to is also sweet if you can drill off the tac welds.