Jump to content

Throttle cable route? (4g63 swaps)

Justin Kresty

  • Please log in to reply
2 replies to this topic

#1 jayfressh



  • Members
  • PipPip
  • 111 posts
  • Gender:Male
  • Location:Cleveland Ohio
  • Model:Conquest

Posted 04 May 2012 - 07:25 PM

Is there a preferred method of routing the throttle cable on 4g63 swaps?

I've looked for pics but haven't found much short of one guy who rotated the throttle body 90* to get it on the outside of the intake.

Are most swappers just cutting out the bend or bending it straight? Is anyone shortening the cable length?

Thank you.

#2 golden87



  • Members
  • PipPip
  • 384 posts
  • Gender:Male
  • Location:colorado
  • Interests:BURL&BOOSTIN
  • Model:Conquest

Posted 19 May 2012 - 09:33 AM

I was just gonna make a bracket to hold the cable on the side of the manifold. I dont know what intake manifold your using but that would play a big part. I haven't seen anything that people say works the best. Just whatever is good for youre setup.

#3 MainstreaM


    Tech Spec LCO

  • Members
  • PipPipPip
  • 4,751 posts
  • Gender:Male
  • Location:Chattanooga TN
  • Interests:Splittin' atoms
  • Model:Conquest

Posted 19 May 2012 - 08:26 PM

Some guys have used the Eclipse cable and I've seen some use one from a Mighty Max.  Best to go to the self service junkyard and pull several of different lengths.


Also tagged with one or more of these keywords: Justin Kresty

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users