Jump to content

tools are fun


Bill Hincher
 Share

Recommended Posts

this is a pullmax P 9 and its what I been looking for, it cuts and shapes centers up to 1/4 in thick, the reason it was important to me was because now I can build any flexplate to any ring gear for any auto trans

http://www.billsautofab.com/images/p9pullmax1.JPG

http://www.billsautofab.com/images/p9pullmax.JPG

http://www.billsautofab.com/images/p9pullmax2.JPG

http://www.billsautofab.com/images/p9pullmax3.JPG

http://www.billsautofab.com/images/p9pullmax4.JPG

they aint cheap, I had to go to Chicago and pic it up and then unload it

now I gotta rest a couple dayz >;o)

Link to comment
Share on other sites

the 5000lbs forklift could not lift it, so I placed it under my 9000lbs car hoist and placed an I beam between the 2 sides and lifted it off the trailer

 

the flying tigers during the war had told the story about the chinese dredging up an airplane from the yellow river

they went down one at a time and wove baboo sticks one at a time under the aircraft until they could winch it up, so I used the same idea

 

I built a trailer under the machine by welding a set of axles together and then placing the tires on the axles and then pulling it with a forklift >;o)

Link to comment
Share on other sites

 Share

×
×
  • Create New...