triforcequest Posted January 21, 2011 Report Share Posted January 21, 2011 I have a few extra quest transmissions and a t-5 out of a 5.0 mustang between 83 and 85 the only I know that the top two bolt for the 302 are the same as the quest trans but i haven't done much more research then that. What I would like to know is if you could cut off the bell housing off a quest and welded it to a plate that would fit a T-5 and had the fly will my be machined to fit the input shaft of the t-5 would this work or am I wrong. the reason I ask this is because i have a auto i would be willing to cutup for research if you guys would think this would work. The reason I want to do this is for fuel mileage because the 5th gear in the 302 t-5 is perfect for cruising with 3.91 rear gears and you could change the first through forth with one from a four cylinder out of a svo mustang or Thunderbird turbo coupe because they are real close to our gear ratio. Then my be I could get 30 miles to a gallon or close to it. I will do some more research but just trying to get a feel out for what you think of my idea. Link to comment Share on other sites More sharing options...
FLATBROKE313 Posted January 21, 2011 Report Share Posted January 21, 2011 Why not just buy the adapter plate ?their is some info here or go to 2.6liter and read the wright up under lower shore perfomance hope this helps Link to comment Share on other sites More sharing options...
sleeper tsi Posted April 8, 2012 Report Share Posted April 8, 2012 (edited) Got ahold of bill:) Edited April 8, 2012 by sleeper tsi Link to comment Share on other sites More sharing options...
Recommended Posts